Hi all,

 

Has anyone tried integrating a Paxton Net2 Plus access control panel with a DSC Powerseries Neo (HS2032) security panel?  I've given it a go but have run into one issue.  The system is set up so that the user presents a token + Pin to the reader, then the door unlocks and the Neo panel disarms.  However, there is a ridiculous amount of traffic running between the two panels.  I get about 12 back-to-back messages every few seconds, even when the system is sitting idle.  Normally, I wouldn't care about this except that it's making the archive file HUGE.  It's now over 25GB after only three months.  I'm fairly certain the traffic isn't coming from the Neo panel as it's not listed in the events history.  The wiring is listed below along with a screen grab of the messages.  (I've blacked out the client's name.)  Any help given would be greatly appreciated!

 

Net2 Sense connected to Neo Zone 3

Net2 0V connected to Neo Zone 3 COM

Net2 COM connected to Neo Corbus GRN

Net2 NC connected to Neo Corbus YEL

 

I assume your using the stock integration ie clean inputs and outputs between the 2?

Absolutely, sir.

It looks like it's continually arming etc. What's the relay state and what if you link the input

Relay state is normally closed.  What do you mean by link the input?

im wondering if you have a bad connection on the plug/pcb/relay on the connection link it at the Paxton to see if the messages stop and work back from there to identify where its coming from

Yes sir, I've done that.  The messages do stop.  I have three sites all set up identically and the issue happens at all three.  I put a jumper on the Paxton panel from 0V to Sense and the messages stop.  However, I can't find a record of all these messages on the DSC side.

Edited April 10, 20197 yr by Joshua613

I'd say your issue isn't Paxton related then. Is your relay stable from the alarm I'm assuming it isnt

I got it figured out.  Rather than wiring the Paxton panel to zone 3 on the DSC, I bought a DSC relay and wired the Paxton panel to that.  I then wired it to the PGM 2 and all is working correctly, now.  Thanks for all the responses, sir!

On 29/04/2019 at 10:57, Joshua613 said:

I got it figured out.  Rather than wiring the Paxton panel to zone 3 on the DSC, I bought a DSC relay and wired the Paxton panel to that.  I then wired it to the PGM 2 and all is working correctly, now.  Thanks for all the responses, sir!

 

Hey Joshua,

 

If you are still here, I need to integrate a Paxton Net2 ACU with a DSC NEO panel. I see you mentioned buying a DSC relay to resolve your data issue. Would you mind sharing the model number of that relay. Thanks