Learned the w/less sab on a texecom 64w kit, wait until all data is collected and all showing ok but no response when the bell test is activated. Tried deleted and relearning, same result. Any ideas?

How are you testing it?

Engineer utility, then do bell test then yes

 

OK, does the bell show in Ricochet monitor? What does the wiring type say for the zone that the bell is assigned too?

Yes it did. Seems to be ok once the data collecting is done and then going in day mode and back in.

So it works now yes?

Yep, the ricochet learning process seems a bit hit and miss though

How far away were you from the panel when you learned the bell. Need to learn everything on close to receiver, then go and put everything up in its location starting with closest to the panel first. The bell is no different to anything else with regards learning so not sure why you had the issue.

Thanks for the tip, done a couple more since and all seems ok now.