I have an Abacus 6 which I installed sometime back.

 

Due to room modifications I want to remove one PIR from the system.

 

After disconnecting at the panel, can anyone advise on how to remove this zone from the keypad display?

 

Thanks.

All you can do is link it out you cannot program it out with the zone open on the Abacus panel 

Thanks for that.

 

Will it just be a case of removing the wires at the panel, 6 wires to the PIR or will I need to bridge any terminals in the panel, zone, tamper?

 

Presumably just disconnect the 12v +/- supply.

 

Will probably jog my memory when I remove the cover.

Assuming that the detector does not have eol resistors then that should be it just put a link in each circuit. 

Thank you.

 

No EOL resistor, onto it this evening.