Paradox Mg5050 Diy Install

[fabzster]

Hi All

 

I am new to alarm systems, but find them interesting and currently  upgrading my Old IDS system to a new Paradox MG5050 system.

 

I was hoping that I could get some advice here, once complete I was thinking of creating a tutorial to help other DIY users.

 

I have 3 x wired panic buttons that were in place from the previous system and 3 x Wireless REM101's

 

I have added 3 x REM101's via Winload and made Button A/PGM Action 1 [8] Panic

 

I have selected Zone1 as the panic zone (I assume I connect 3 x Wired Buttons to Zone1)

 

I am then not sure what to select on PGM1 (For Panic) Do I select a Group and make all the wires panics belong to Group#8?

 

And for PGM2 for the Normal Alarm to go through, what do I set that to?

 

And then how should I wire My ADT Radio to the Board & PGMS’s?

 

Any assistance would be appreciated.

[al-yeti]

Never used this panel, but pgms are your outputs yes? As in optional outputs and the provided the zone is programmed as a panic should work regardless of the pgm output?

Can you not put each button on its own zone? Easier to identify then