Jump to content
Security Installer Community

Fire Alarm System Into Intruder Alarm


Recommended Posts

Sounds good to me. And for a non pro carrying out this work fair play, because there are a lot of engineers out there that would have issues doing this.

Need any help please revisit.

Good luck bud !

Thank you! I appreciate that alot.

I'll be sure to keep everyone informed ... as I run into troubles along the way no doubt.

Link to comment
Share on other sites

Guest old-hand

Just to stop you for a second.

Did you work out the loadings independently for the panel and PSU. As they will not be powering each other under a mains fail.

As you gave a total power consumption in your calculations.

cheers

Link to comment
Share on other sites

Just to stop you for a second.

Did you work out the loadings independently for the panel and PSU. As they will not be powering each other under a mains fail.

As you gave a total power consumption in your calculations.

cheers

No that was overall.

So the PSU is not wired into the Panel (for power sharing) its just A&B lines linking the two ?

May mean that I will need more backup power in the PSU than in the Panel.

Worst case is that I put the biggest physical battery I can in each of the Panel and PSU.

Link to comment
Share on other sites

your 1A galaxy will only support a 7A/h however your 3A smart psu will support a 17A/h

I would load the panel the lightest so that the smart ran out first. YOu can use that application of ours to work out the loading accross each supply

securitywarehouse Security Supplies from Security Warehouse

Trade Members please contact us for your TSI vetted trade discount.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.