Guest Guest_Mark Posted February 3, 2004 Share Posted February 3, 2004 We had a power cut yesterday. After power was restored and the alarm stopped we found we could not enter anything on the keypad - pressing buttons does not give a "beep" as usual, we cannot reset or arm the alarm. I have read about low battery causing a problem but I would have thought it would charge up again, is the lack of any response from the keypad the same problem? Thanks for any help. Link to comment Share on other sites More sharing options...
FASTCAR Posted February 3, 2004 Share Posted February 3, 2004 If you feel confident , remove mains power , open the main cover , remove the battery connections , restore mains power (the system should wake up- enter your code) replace / reconnect battery , replace cover , press reset , all should be fine!!. If in doubt , call a local engineer and have it serviced . Link to comment Share on other sites More sharing options...
Guest Guest_Mark Posted February 3, 2004 Share Posted February 3, 2004 Thanks - feeling confident so I'll try it tonight. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.