Guest stuart Posted January 15, 2004 Share Posted January 15, 2004 I have 5 zones but when trying to set the alarm, LED 6 illuminates as though Zone 6 has been left open and hence the alarm will not set. Any ideas? Link to comment Share on other sites More sharing options...
FASTCAR Posted January 15, 2004 Share Posted January 15, 2004 Hi , Short term fix , omit zone 6 .(user guide available at www.texe.com) Then either get in an engineer , or open the panel and check that the link is still in zone 6 . Is it possible that an extra device could have been added , but not written on the plan?. Link to comment Share on other sites More sharing options...
Guest stuart Posted January 17, 2004 Share Posted January 17, 2004 You were right. When I opened the Control Panel there was indeed wiring to Zone 6 which I finally tracked down and closed. Everything works fine now. Many thanks Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.