superfixed

Thanks done it.

I have another look and the only thing near the panel is the keypad no A6 box. I have been to system outputs and and output 1 is the first listed and at present its off. I have played around but so far have not found areaB set up

The former owner was in IT I believe he fitted the alarm himself and left me with all the codes, I was not phased about this as it works well and thinking I know a bit about these things I obtained a manual on line. Having done relay fitting before I thought I could do this fairly easy but I cannot see in the manual how to do it. I am pleased I can use other outputs but I still need to programme it. If its possible without putting you to too much inconvenience could you give me step by step guide to programming o/p 1 to activate on an alarm in area B. ie what main section I need such as global then the sub menu and so on thanks in advance.

I have looked at 19 but no help

I have looked in the panel and there is a sheet with zone information on it and various comments and one entry says that firmware has been updated to 5.02. As regards model the panel is plastic has 8 zones and there is in other part of the house an expander I require the relay so I can switch on lighting and a sounder in the garage ( area B ) if its broken into, I did this at my old house The relay I will use is 12volts and draws 45ma.

Greetings this is my first post. I moved home a few months ago and the property has a Texecom premier elite alarm. I have been investigating and have obtained the engineer code plus a manual, I have some skills I think in such things and have noticed on the pcb there is a terminal marked op1 I wish to switch a relay from this on any alarm in area B ( there are two areas in the system ) Could anybody take me through the set options to do this.