forumflyer

Ok, would it work with one wire on 0v and other on tamper thanks

Hi i have a texecom sab and have wired it into the control unit but it only has one tamper wire connection. Where is the other meant to go to complete the circuit. Thanks

It has a laser break for safety installed. The problem we keep having is that its set on timer down but the moment the time lapses it starts to raise again??

Hi, I have wired in a roller shutter door to one of the relays on the net2 unit and on the programme set it to toggle. It will open the door but wont close it. The roller door unit is set right. Maybe it shouldnt toggle? or i have put the wires from the door in the wrong way. Ideas appreciated

Thanks for your swift responce So the from alarm (texe unit) which two am i wiring it from on the texe board

Hi, I have a client wanting me to connect up a paxton net2 unit with a texecom alarm system as it should be able to unset and set the alarm on entry and exit. The problem i have is paxton diagram is not that clear. It says i need an momentary key switch input 2 wires this is coming off a relay (where do i wire these to on the texe?) And also from the alarm it want a voltage free status output again 2 wires, where do they go and what colours Seems very hard to find an answer on this considering paxton sell alot of these units! Thanks