gazh

Thanks lads for the info its much appreciated , going to replace the whole lot soon just needed this sortin for now..which is the best wireless upgrade to go for

hi yea there are 2 wires going to the micro switch do you say its ok to loop the 2 wires together and remove the switch , the switch do,s plug into a pcb but id rather not mess around with it , the wire are yellow and red

hi , wonder if anyone could help with problems concerning yale wireless alarm hsa 3000 series when on sunny days the alarm go,s off on its own , i found out its the tamper switch inside the alarm siren box and the cover must expand with the heat of the sun causing the tamper switch to move , ive tried a few times to pack the switch so the switch is tight closed but after a while im back to square 1. the question is can i disconnect the tamper switch or loop the yellow and red wires together or maybe just fit a 12v on/off switch to bypass this. any help appreciated

hi lads can anyone help . ive got a veritas 8 system in my house which was installed before we bought the property , the alarm has been working ok up till now where when we set the alarm itjust keep beeping and wont set , when doing a walk test its saying zone 3 which is just a pir , even when alarm is not set the pir is just constantly flashing on and off , is it time to change the pir as im assuming there is nothing wrong with the wiring as its been working ok . any help appreciated thanks gaz