tigger390

You're a star. Thanks.

H there, thanks for the prompt response. That is good news, but I don't remember the last 9651 I fitted doing it and Accenta's etc don't do it. Maybe my memory isn't what it was!

Right, as I am new here I am taking orders at the bar! Mine's a pint of Amstel! Now that's out of the way, today I replaced my old Accenta Gen4 with a Scantronic 9651 panel and 9941 pad. All of the wiring transferred across with no problems and the system works fine. Walk tests, output tests and global tampers are all ok. The problem is on pressing 99 tick, to exit engineering I get a 'checking bus' message that last for 20-30 seconds then it asks again if I want to exit engineering, on pressing tick I get another checking message and then it goes to day mode. I know there is a problem in that the strobe doesn't work on the bell box and I will be replacing the bell box with a deltabell plus tomorrow. Is it possible the panel can see the strobe fault? I have installed and programmed this panel before with no issues so am baffled as to what the problem is. Thanks