stelmo

Im concluding that this is some sort of obfuscation of the event(Personal attack input), whilst also indicating that something needs dealing with? Ill go through the event logs, but ive come to the conclusion that this is by design, and not documented

Definitely says 'System Fault, Reset Required' According to the manual it should result in 'no audible or visual indication of the activation'

Im sure there is an obvious answer to this but its baffled me Ive wired up a relay to zone 2 on a galaxy dimension and set the function to PA silent. when the relay opens all I get is 'System Fault' ive got a 1k resistor in series then a 1k across the relay, so it measures 2k when open and 1k when closed If I change the function of the zone to intruder, from pa silent then opening and closing the relay gives no error! bizarre...

Thanks for that Ill give it a go

Can I set a trigger output from the panel that say when the door opens it controls a relay even when the alarm is not set? i want the input to go to the lights control, save me wiring up other sensors Galaxy Dimension 96 with RSS It would probably be wired to an entry exit zone door switch

I see an option for the backlight for the screen on/off but not the keys brightness level

I just thought there was maybe some key combination to adjust the brightness I guess they are just duff

yea doesn't seem to be a voltage problem

Not sure what you mean there all 3 are MK8, 2 of them seem have very little in the way of backlight behind the keys

I have a couple of Galaxy MK8 keypads and for some reason the key backlight is hardly visible My other MK8 is bright but these 2, barely lit, is there some way to adjust it? I see no controls on the PCB. The screen backlight seems OK

Does anyone have a CEL Discovery/Voyager panel lying around with the printer interface they could part with?

Looks ideal, thanks

Ment to say also that I dont want to use the wireless offering via the RF module, Id rather hard wire them So presumably just find a smoke detector that has a relay output and wire it upto the zone?

I have a Galaxy dimension, which has fire zones I see in the manual. Anyone have experience of connecting up detectors to this? or is it best to stick to a dedicated panel?

that will do all connected modules will it, not just just the galaxy panel? Scrub that question, i see the e080 has its own spi socket

Hey How do I get my E080-2 upto the latest firmware? I think it needs 2.11 Is it via the SPI key process? or can I do it from the RSS Suite? elmo

is it available on the net?

Fair point but the whole lot with detectors is here now in a box ready to go, seems a shame to waste it Plus the Gent nano is a small unit for domestic / small office environments

Unit is still in the box, I haven't looked at it since I last posted. However I'm getting to the point in my house build to decide to use it or not. Would anyone be able to get me a copy of the firmware? I'm on V2.56 at the moment

Good enough for me, thanks

But its regular as clockwork, every 60 seconds - just ignore it?

Well I did say it was the panel that was clicking anyhow forget about it I'm bored looking at it Thanks for the suggestions everyone that was kind enough to offer useful input.

Ive tried running it with just the isolated base only (no device attached) and only a single call point I think ill bin it to be honest, I dont trust it with this clicking that its doing

This relay These are internal relays that are not programmable, if I understand your question

Nah nothing made any difference When the loop is powered down this clicking doesn't happen