burger Posted February 15, 2009 Share Posted February 15, 2009 I've got a Scantronic 500r+ wireless system - problem is I can't change the Entry/Exit zone, but here's the build-up to why: - Entry/Exit is the front door with a magnet sensor, but door replaced (zone 1) - Took sensor off, found it wouldn't fit, so fitted to a scrap bit of wood. Tampers sounded whilst doing this etc but all reset OK i.e. control board and alarm is working fine - I'm trying to change the Entry/Exit route now to a different zone (zone 2)_so that I can do Full Set (as the sensor is now not on the front door) - I get into programming mode and do a '93' but the zone 1 LED lights up red and the tamper LED lights up red - Only lights on the control panel are normal, i.e. Green LED for AC Power and Standby Any clues? Link to comment Share on other sites More sharing options...
Alarm Co Posted February 15, 2009 Share Posted February 15, 2009 I've got a Scantronic 500r+ wireless system - problem is I can't change the Entry/Exit zone, but here's the build-up to why:- Entry/Exit is the front door with a magnet sensor, but door replaced (zone 1) - Took sensor off, found it wouldn't fit, so fitted to a scrap bit of wood. Tampers sounded whilst doing this etc but all reset OK i.e. control board and alarm is working fine - I'm trying to change the Entry/Exit route now to a different zone (zone 2)_so that I can do Full Set (as the sensor is now not on the front door) - I get into programming mode and do a '93' but the zone 1 LED lights up red and the tamper LED lights up red - Only lights on the control panel are normal, i.e. Green LED for AC Power and Standby Any clues? you need to delete zone 1 and 2 from panel,,,, then reprog the old zone 2 to zone 1 to get it onto entry exit,.................... you need to delete zone 1 and 2 from panel,,,, then reprog the old zone 2 to zone 1 to get it onto entry exit,....................and if you got tamper light on when you trying to exit prog then the lid is still open on ya door contact , if you want to keep the door contact you need to go into prog and add extra entry/exit zones............... Link to comment Share on other sites More sharing options...
burger Posted February 15, 2009 Author Share Posted February 15, 2009 you need to delete zone 1 and 2 from panel,,,, then reprog the old zone 2 to zone 1 to get it onto entry exit,.................... Got it working - thanks pal. Also, just to help others, I wasn't in programming mode so what I was seeing was the log as the panel recognised the 3 and give me last entry in log. Went into programming mode with eng. code and sorted. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.