i was doing a routine maintenance service today on a 2002 veritas R8+ and the house owner said the alarm went off about 2 weeks ago internal sounders only when it wasnt set, so i automaticly thought of tamper fault.

so i checked the log and it showed tamper as the last activation.

ok BUT...

when i hit omit for the extended log it flashed on 6.

going by the prog book 6 is N/A

1 bell tamper (inc global system tamper)

2 N/A

3 lid tamper (inc rkp)

4 line monitor

5 rkp off line

6 N/A

7 N/A

8 eol tamper

i couldn't find any obvious tamper fault and all the readings were tip-top.

has anybody come across this before ? is there something texecom forgot to put in the install manual ?

6 = code pin tamper in my manual.

thanks.

the manuals must change down trough the years. as the manual i flicked over today was from a 2007 panel, still the old lady said the system went "koo koo" lol about 10 minuits after it was unset, she lives of her own & no kids to fiddle with the rkp. must have been a sticky button to cause a code pin tamper ? me thinks.

Sounds plausible...

BTW 7= keypad PA