Jump to content
Security Installer Community

New Bell Box To Concept 6 System


Guest Nigel

Recommended Posts

Guest Nigel

I have a concept 6 system from //.National Installer.// which has a seperate keypad wired - this shows no lights.

I believe the battery may be the problem - few years old.

I have ordered a new battery, but thought a new bell box would be useful as the old one no longer works.

I have purchased an odyssey 1e and battery.

The alarm panel is still connected to the mains with powerlight on, but not keypad working.

Do I just switch off mains, install new alarm box - which only has 5 wires and not 6 as shown on control panel (do I disregard the strobe + connection on the control panel).

Then put new battery on , close control panel and switch on mains?

Any advice would be ap :hmm::hmm: preciated. :hmm:

Link to comment
Share on other sites

Hi ,

I would make sure everything works first.

Remove the mains , check inside the panel , remove the battery if there is one, check all connections , previous owner may have snipped a few.

Fire it up mains first , if you have a code , use it , if not try 0123 , if that doesnt work , turn the power off.

Regards.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.