[i-on40H internal sounder connections]

Use the out puts and progg to follow partition not sure how much current your sound one draws possible use smart relay just in case 

[i-on40H wired sounder temporary muting]

Progg a bell delay long enough for you to carry out what you want to do then reset as normal ( remember to remove )

[Can anyone identify this system for me?]

Would agree one to be replaced 

[Which Cloud to choose]

We use Menvier dose drop out some times ( prob all do ) over all good site 

[Pyronix Enforcer bellbox, comfort strobe?]

Are you looking for the strobe to give you conformation of setting /unset coopers panels can give you a 3 strobe flash on both so might be in setting progg

[TS900 Engineer mode tampers]

Engineer on site means you have left engineer  put in your code then ent ent 1

[I need your advice - control panel]

Take a look at the Ion 40 H

good robust easy to use and secure app

[Which Wireless Kit?]

Yes we did have a lot of keypads to replace then they withdrew the 'new ' keypad due to using batt to quick !! Only had 1/2 that did that but never recalled we still have them on the shelf but do we fit or will give us problems !! 

[Which Wireless Kit?]

We use the Eton kit ( Menvier )now badged Ion 

use 30 r and 40 H both have proven them selves ( most of the time ) also Memvier 40 with bolt on wireless all the same periphirels across the range and the new app for 30 and 40 is good and reliable 

worth a look at Tec back up not as good as used to be and never see a rep 

Allan M

[Intruder alarm Smoke sensor recommendations]

We use the coopers M12 and fit remote sounders and an Expander PSU - along with Ion 40H remote access to sys

tem  with coms works very well and quick and easy to identifie fault/fire alarm  not always so easy on the mains operated ones

[Domonial - keypad issue]

Sounds like it's set up to lock the key pad out on entry will prob let you use a code to unset once entry timer has run out if this is the case just have to find the setting in DD243 

[Viper Foam Detectors]

Might have an viper one in the old parts cub will have a look see

[Oldest Panel]

Hi to all,

I was recently called to an address which seemed familiar, when i got there i remembered that it was my first installation as an engineer. The alarm panel was a Metal ADE Logic 4 ( for the newer engineers, yes they used to make them from metal......)

To my surprise it was still going strong.. no problems at all, just needed the back up battery changing.

No matter how much i tried, the couple refused to upgrade, all this new fangled technology is not for them...

I just wondered what is the other installers first panels were???

Great forum love reading the topics ...

the 1st panel we put in was a tunstall CPA6 in a school where we had the Electrical contract Quite a hard one to start on but made the next (A1 9000 ) easy