Dmc112

Thanks a lot for your help, much appreciated ?

Ok, so l’ve finally sussed it in “Arming modes”. Part set had originally been set to instant as there were no devices that triggered en-route from the keypad to the upstairs. Now that l have a device (PIR) there, there is. Ive set the Part Set arming mode to Timed and all is well, well nearly..... The Exit time is set to 30 seconds to allow time on Full Set to walk to the front door, grab my keys, open/close door etc. When Part Setting l like to hear the setting chime so l know it’s done, however, that now takes 30 seconds, by which time lm in my bedroom. So, is there a way to have two timers? I.e. Full Set left at 30 seconds, Part Set at 10 seconds?

Sorry, to be clear, l have an entry/exit set to the front door which is off the hallway. What l meant was that when setting the part set at night l don’t go past any other devices, just the downstairs hallway PIR as the upstairs ones are set to Omit Would you happen to know where l can change the part set timing from instant to timed and where the l can change the amount of time?

I have the exit delay set to 30 seconds but l’ve gone through all the timers (at least l believe l have) and there doesn’t seem to be one specific to Part Arm, although lm guessing it must be hidden in the menu structure somewhere....

Hi. l don’t have any other devices on that route, just this one PIR. I was considering setting the Forced Arm attribute on and seeing if that would allow it. My Part Set Arming time is very short (approx 3 seconds) but this has never been an issue before as l had no device in the exit route before. l guess it would be best to increase the Part Set Arming delay to allow me time to walk past the PIR, but l can’t seem to find this option in the manual??

Tex24, did you ever resolve this? I installed my alarm (Premier24) a few years ago. I recently knocked two downstairs rooms in to one so had a ‘redundant’ PIR. It was a simple re-route to have the PIR look at the bottom of the stairs, the idea being to set it to Guard Access so would set off the timed entry warning to remind me/the kids to disable the Part Alarm as they go downstairs (too many false triggers when they forget). l now have the same issue whereby if knset the Part Alarm and still still by the keypad all is good, once set if l move the entry warning triggers and l can unset the alarm without triggering it. The problem is that if l Part Set the alarm and then walk past the PIR on my way to the stairs the alarm won’t set and it comes up with a ‘Zone 1 (Hallway) alarm fail’?? It seems that when the PIR is triggered, it stays triggered for 3-4 seconds before the LEDs go off again. If the LEDs are alight as the alarm sets, it comes up with an Alarm Fail. l think an easy solution/get around would be to delay the Part Arm set, this would allow me to walk past the PIR, triggering it and then allowing the 3 second delay for the LEDs to drop off, but l can’t seem to find this on the keypad menu. That said, l don’t know why l can’t set the Part Arm with the Hallway PIR triggered when set to Guard Access as surely that’s what’s for...?? (by the way, all my attributes are */off)