Efit2005

Hi, that was the first thing I tried and have done numerous times since. I am hoping the reset will do it like the guys have suggested

Hello, sorry I was reading the manual where it says press ## on powering up the panel, so assumed it has to be powered done first. I do know my engineers code and have found the other way of resetting it, so will try that at the weekend. Thanks for the assistance chaps

Hi Gents thanks for the replies. Regarding the reset, is that power down panel and disconnect battery, then reconnect battery, close panel and power up, then ##? If so, how long is everything meant to be disconnected for?

Hello all, My first post so please be kind. I have an accenta g3 with the remote key panel. The alarm went off the other day due to taking too long to turn it off. The alarm bell disarmed as expected, but the strobe continues to flash. I have checked the control panel battery which was 12.7v and I have also changed it because it is over 10 years old. I have also tried a power down reset to no avail. The strobe will stop if I disconnect one of the wires on the control panel for it, but will start up again if the wire is put back on. I have measured 13v across the strobe + and -. But it does not appear to alter the voltage as I would expect when the strobe flashes. This would indicate a bell fault wouldn’t it or am I missing something? Thank you in advance for any help/assistance