Hello,
I came across a Scantronic 9600 System today, they are a bit before my time.
When performing the procedure of defaulting the Engineer code due to the age the IC8 chip it was brittle and damaged.
On the chip were 2 lines as follows
93CS66B1
92A422
My question is, is it as simple as getting a new chip and popping in then setting up again or is there more to it?
Also found a similar post and this was recommended for the replacement chip, would this work?:
https://www.google.com/search?q=24C16%2FM24C16-WBN6P+DIP-8+Serial+I²C+Bus+EEPROM&oq=24C16%2FM24C16-WBN6P+DIP-8+Serial+I²C+Bus+EEPROM&aqs=chrome..69i57j69i58&sourceid=chrome&ie=UTF-8
Thanks in advance!
-Thomas