little_john
-
Posts
8 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Downloads
Gallery
Blogs
Posts posted by little_john
-
-
15 minutes ago, al-yeti said:
Can't remember now about that jumper , but if it solves problem then select g2 if it doesn't then put the resistor in correct place
-
10 hours ago, al-yeti said:
All makes sense now
I had this problem myself not wiring the g3 correctly , had to get mr alarm monkey to help me (JW)
In picture you sent there's a link same batt int or ext , you need to select ext
Then the g3 module is waiting for power on a terminal meaning another resistor
You should have bought the G2 module would saved you lots of time
J4 can be selected as G3 / G2 ?, and J8 will set to ext, i cannot test it again until monday, just want to say thanks for your input with this.
-
16 hours ago, al-yeti said:
Confused
In list you say z29
Than you say z30
Also battery isn't enabled
Which deltabell is this ? You still got the box? With code on it?
the part code FPDELTAX3MOD Deltabell X G3 Module, (backlit, twin piezo) i changed to z30 i got visonic data sheet for expander to hw bell and to refers to z30 all the time for tamper, how do i enable battery ?
-
43 minutes ago, al-yeti said:
What you mean set to 24h audible? Y?
if bell is tampered with, set/unset it will produce alarm on the panel. when i close the lid the siren goes off, but nothing reported from the panel
-
Hi thanks for reply’s i am pulling my hair out with this (the expander is outputting 12V), i have now tried jumper on scb (bell still goes of when lid closed ?) and wired the tamper to z30 and set it on panel to 24h audible this is how i have got the connections
EXPANDER ~ SIREN
12V ~ 12V
GND ~ GNDEXT - BELL
SRN+ ~ ENGHOLD
INT ~ STROBEZ29 (2.2K) ~ TAMP
GND ~ TAMPOn panel bridged tamp with 2.2k
Jumper now on SCB
Using Z30 as tamp and have set it to 24h audible
have attached pic of other jumpers
-
Hi i have visonic pm30 panel with expander card and trying to connect a pyronix deltabell (using the light box face) i have got some info on expander and sounder connection, so far when i power it on with bell lid open it light up ok soon as i close the tamper on bell the bell go off (panel is ok and other wirless bell is ok) . i have closed the tamper and fault connection on bell just to try and stop it going off (was only going to wiring the tamper to z29 with resistor once bell is stable) any help or pointer woulds be greatfull.
thanks
-
Just saying HI
I found the forum a while ago, while search for cctv, alarm info, I install mainly hikvision kit and visonic, pyronix and Texecom.
I hope to learn and share like the rest of you.
john
galaxy bell wiring
in !!..DIY Installers..!!
Posted
Hi i am trying to connect a FPDELTAX3MOD Deltabell X G3 Module, (backlit, twin piezo) to a galaxy dimension 48 ( have moved jumper on bell to G2) have tried it couple of ways into rio 0 with std galaxy setting, could do with correct wiring (or bell goes of when closing bell lid), i have follow info in post below any help would be really greatfull thanks.