-
Posts
7 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Downloads
Gallery
Blogs
Posts posted by LeepyLee
-
-
-
Yeah, as I say assuming the cabling is OK, once proved, is there a way to prove if the keypad or panel is at fault other than by swapping one or the other?
I.e. by using a meter, is it possible to test the data pair both ways, looking into the panel and into the system; what conditions should I see or measure?
-
This system is in a rental property that's been empty for a while. Last tenant never knew the codes so never used the alarm.
The internal sounder only, was going off when landlord & I visited. He managed to silence the sounder by using the 'poke & hope' method. But after that, no response from panel... obviously because of data fault.
As there are only four wires (presumably power & data pairs) between panel & keypad, its easy enough to prove the cabling. Assuming the cabling is OK, is there a way to prove if the keypad or panel is at fault other than by swapping one or the other? The keypad is obviously getting power as the display is lit.
-
Thank you all!
I particularly like the 150 yrs old comment! Not a lot of help, but my kind of humour!
Thanks for the link to Manager Manual too, but does anyone know where I can find a programming manual please, in case I take up the challenge to reset/default or start from scratch?
-
That's great! Thanks for the quick reply.
Any thoughts on what the problem may be please?
-
Hi,
Just wondering if anyone can identify this alarm system please?
The panel is showing "nd-NO PANEL DATA" and all three LEDs are illuminated.
I know the battery is no good and needs changing. All fuses seem to be good (with a meter across them).
The codes are unknown, so will need a factory reset I guess.
Thanks all!
Identify this?
in Guest Forum
Posted
Thanks for thatThanks for that... yellow man though?