pjm1959

Currently, have a CEF AP28 keypad/control panel. The front cover keeps on falling off. Am I able to replace the keypad with a new one or will I have to change the control panel as well?

N No, bone dry

No not really. It happened last Monday night. It had been windy, but the bell box was secured using four screws. Am I able to test the tamper circuit on the bell box using a multi meter and if yes what do I do?. Thanks for the replies by the way. :-)

Bell box is on a perfectly flat surface. (K rend)

I have a ADE Gen4 alarm with a Honeywell AG6 sounder & strobe. (Self installed)The other night while in the house the AG6 sounded. Inputting the 4 digit code didn't stop it. I ended up removing the fuse from the electrical supply and removing the battery.Four hours later (midnight) (no electrical supply or battery connected) it started again so I removed the wires from the AG6 into the Gen4. This didn't stop the sound (it stopped and started every few minutes and sounded like a crackling noise) so I ended up climbing up a ladder and removing the box from the wall.The box is now in the house so has been disconnected for over ten hours, but LED 2 is still lit.Talking to someone from ADE technical support this morning they told me it was a fault in the tamper circuit. Is some able to conform that this MIGHT be the problem?Am I able to disable the tamper switch on the bell box and if yes how? Thanks in advance.Peter

Anyone??

Hi folks Am doing a self install on a new build house and need some help on a few things if you don't mind. I have the following: Accenta mini gen 4 AD-01 Auto dialler AG6 External sounder & strobe. 1) How do I wire the Auto dialler into the gen 4? Terminals on Auto dialler are: Tamp (x2), TR2, TR1, 0v & 12v+. Think these wires should go to Panel J3 on the gen 4 and the terminals are +13v, 0v, Fire, PA,INT, SET & ABORT? 2) How do I wire the External strobe into the gen 4? Terminals on strobe are: ST- (strobe trigger), R- (Tamper return), SW- (Sounder trigger), V+ (positive supply & V (negative supply. Think these wires should go to Panel J6 on the gen 4 and the terminals are : + strobe, - strobe, T (scb), A (scb), D (bell), B (bell) & set. Thanks in advance Peter