Phuddy48

Thanks, I've changed the 2 PIR sensors across the alarm and tamper and it seems to be working better. I'm going to re do the door contacts tomorrow and then start the programming again. I'll update if I nee any more help. I hate intruder Alarm systems and this is one of the reasons why. :-o

The jumpers on the board are set to 4k7 for the alarm and 2k2 for the tamper.

I'm using the Texcom compact. 6 terminals on them. + - Al Al Tam Tam. set the resistors to 4k7 and 2k2 as in the manual and the door contacts are grade 2 with the wire cut for the resistance to 2k2.

I'm using the texecom PIR's with built in resistors, so, if I want those to show I need to program them as 4k2/2k2 at the keypad? correct?

Hi Guys, I've bot been on here for a while and could do with some help again if anybody can provide it. I've just installed a Texecom Premier Elite and NOTHING is working the way I need it to. I've wired everything EOL. There are only 5 Zones on the system. I've been banging my head against the wall with this over the weekend and come to the forum for assistance. So, Everything is EOL, the door contacts x 3 and The PIR's x 2. I powered the system up and checked all the connections and the EOL resistors are set to 2k2. when I program the system as eol it is showing system faults and bringing up the call engineer status on the RKP. I have also tried programming the system as Normally Closed but this stops the system working at all. I only do one of these every 6 months or so as the company I work for specialises in CCTV so I haven't had to deal with this for a while and have probably forgotten something blindingly obvious. I've set the system up so that the last Zone on the system is the global tamper for the PIR's etc. Any help would be gratefully received.