smashwings

J&D , in Zone Attributes 2 there is "Enable Force Arming" as an attribute to a zone "The user can arm the system/partition with the zone violated." I don't know if this attribute can be assigned to the "Delay 1" zone (entry), I suppose yes, Also I asked to Texecom mail and they answered that "the international panel it is automatically a timed set" "As long as the zone is not active once the timer has expired then it will set". Anyway, if Timed exit works from default or Force arming zone can be set as an attribute, there will be chances for the PIR to work as entry sensor

Have looked at the Elite Manual and it includes the Timed Exit, but not the Premier one, so it's not available for premier panels? (don't have the panel to test, only manuals)

Thanks, but cannot see how timed arming is activated in the installation manual, can only find some references in outputs section

Hello, would like to set a Texecom Premier 816 with a wired PIR sensor in entry hall (no door contact) , and would like to know if this sensor can be active while arming the alarm because the PIR sees me in the hall. (In an old DSC PC1500 I had, door sensor should be closed) Entry/exit zone in installation manual says "The zone can be activated during the exit mode without causing a ‘Fault’ " ,I don't know if zone can be activated only after arming or if it also refers that it can be "active" while arming. Thank you

Hello, I've just bought the house and having now taken out the sensors to realise that they are wireless WLS904PL, so will only work with the DSC main panels, I tought the main panel was removed in the past but found it despite owner didn't know where it was. I'll try to program it so will ask any doubts in other posts, thanks

Hello I have wired DSC PIR sensors and would like to know if they will work if I wire them to another alarm brand panel, like Scantronic or Ademco. Thanks These are the sensors