BveshPatel

Would it matter if the contacts do not have a specific tamper terminal? I am using the CQR 1 Reed 5 Terminal Surface Contact Grade 1

There maybe a little bit of a confusion here. It's not multiple FSL but rather two contacts on a single zone is using FSL/EOL where the last contact has the 2k2 resistor in and the first contact only has a 4k7 resistor.

This topic maybe exhausted but I couldn't find s definite answer hence why I am asking the question ; On a scantronic 9651, software version 4 can you have multiple magnetic door contacts on the same zone using FSL? I have currently tried this however I am getting tamper each time a contact is opened and wondered what could be the cause as I have tripled checked the terminations and can't seem to find the fault. I am able to exit engineers mode without any tamper however when a contact is opened it goes directly into tamper, however if I have just one contact connected it works fine. I am using 4k7 for alarm and 2k2 for tamper.