[On Board Kp?]

is a panel with an on board key pad compliant ?

 

I was under the impression hat the panel had to be off the entrance/exit zones ?

if the kp on the panel is used as the primary method of set/unset then the zone the panel located in would have to be on the entrance path ?

 

 

[Arc Receiving Software ?]

hi guys,

can some one point me in the direction of a ARC software that can receive via a 56k modem or similar ?

or is there is a cheap hardware interface.

cant seem to find anything via google etc.

 

i have been using software that came with the texecom panels and its not bad, but i can't get it to interface with pstn.

 

any help would be good as the project i am working on, has no option for ip or gsm.

 

this is just a short term project so not looking to set up a dedicated full time ARC, just need to monitor some panels over the phone for a few weeks.

 

thanks for your help .

[Legislation & Standards In The Usa]

I was licensed as an Investigator in 3 states and installed overt and covert cctv they all required different licenses permits and federal registration. most importantly however you needed to have a low voltage elec license  for anything including 12v cams.

pm me for more

[Pd6662 And En 50131]

thanks for the help.

as far as I am aware I have been fitting to all relevant standards. however hard to know 100% without having them in the office.

I am off to find a uni student

thanks again.

[Pd6662 And En 50131]

Ok, I have just left my company and have gone independent.

so when setting up shop I discovered that the required documents pd6662 en 50131 etc, cost a small fortune.

am I missing something is there a way of obtaining the documents for free or do i have to pay an arm and leg?