dylan1055
-
Posts
5 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Downloads
Gallery
Blogs
Posts posted by dylan1055
-
-
hi guys,
can some one point me in the direction of a ARC software that can receive via a 56k modem or similar ?
or is there is a cheap hardware interface.
cant seem to find anything via google etc.
i have been using software that came with the texecom panels and its not bad, but i can't get it to interface with pstn.
any help would be good as the project i am working on, has no option for ip or gsm.
this is just a short term project so not looking to set up a dedicated full time ARC, just need to monitor some panels over the phone for a few weeks.
thanks for your help .
-
I was licensed as an Investigator in 3 states and installed overt and covert cctv they all required different licenses permits and federal registration. most importantly however you needed to have a low voltage elec license for anything including 12v cams.
pm me for more
-
thanks for the help.
as far as I am aware I have been fitting to all relevant standards. however hard to know 100% without having them in the office.
I am off to find a uni student
thanks again.
-
Ok, I have just left my company and have gone independent.
so when setting up shop I discovered that the required documents pd6662 en 50131 etc, cost a small fortune.
am I missing something is there a way of obtaining the documents for free or do i have to pay an arm and leg?
On Board Kp?
in Regulations & Standards
Posted
is a panel with an on board key pad compliant ?
I was under the impression hat the panel had to be off the entrance/exit zones ?
if the kp on the panel is used as the primary method of set/unset then the zone the panel located in would have to be on the entrance path ?