I'm currently working on a site where the customer has insisted on using a galaxy dimension so that he can use and aftermarket network card to remotely control the system via his phone, even though we have advised this can be done with gardtec panels aswell without the need for third party hardware but the customer knows best.........supposedly.
The issue im having is having never worked on a galaxy before and the nstaller manual might aswell be in german it makes that little sense to me, I can't seem to understand how to connect the bell boxs to the panel, the job in question has 2 nova bell boxes one in SAB format the second in SCB so as not to put too much strain on the board when active. The manual states there is relays (not traditional bellbox wiring terminals I'm used to) relay 1 being for sirens relay 2 for strobe 3 for pa and 4 for reset, now the issue I'm having is the relays it seems to be indicating there seems to be two sets of relays both labeled in almost the same way except one is rio 0 then with numbered outputs 1-4 with what looks like a NC circuit inbetweeen then and then theres rio 1 which is also numbered 1-4 but without what appears to be a NC circuit section, theres doesnt seem to be a constant 12v output for the bell like im used to and the manual states that the relay outputs are under positive power via a 3k pull up resistor, now by now im pretty sure you can understand why I'm at a loss as to how to wire the bell boxes and my boss isnt exactly being helpful just being told to figure it out it.
Here is how im used to wiring the bell boxes
sab - panel
12v - 12v
0v - bell hold
s- - bell-
tmpr - sab tmp
with a link on the bell between tmpf and 0v for tamper return
Any help to point me in the right direction with be grately appreciated