Dazza1982

One last update after the customer having issues with the system since we did the hand over he now wants it ripping out and a different unit installing as the mobile app and desktop software isnt working the way he hoped it would

honestly fella the tamper output next to the programable outputs that can be used for the sab was giving a 12v output. had rio0 outputs then aux 12v then rio1 outputs then aux tamp then gnd and aux tamp-gnd was reading 12v

Finally the heap of s&@t is done with, certainly the last time I let the customer dictate the equipment used and provide it specially when it's refurbished equipment that turns out to be faulty, plenty of head scratching occurred specially when connecting the bells in and it's blowing fuses turns out the Galaxy dimension puts a 12v supply through the tamper loop for the bells so can't have a common 0v and tamper return like can on Gardtec and telecom panels Thanks for the advice on the programmable outputs was far clearer from you guys than the manual

I've done some programming on galaxy's but not been inside them hence my problems so I'm aiming for the rio1 outputs just to clarify and can program them to control my siren strobe and tamper etc?

I'm currently working on a site where the customer has insisted on using a galaxy dimension so that he can use and aftermarket network card to remotely control the system via his phone, even though we have advised this can be done with gardtec panels aswell without the need for third party hardware but the customer knows best.........supposedly. The issue im having is having never worked on a galaxy before and the nstaller manual might aswell be in german it makes that little sense to me, I can't seem to understand how to connect the bell boxs to the panel, the job in question has 2 nova bell boxes one in SAB format the second in SCB so as not to put too much strain on the board when active. The manual states there is relays (not traditional bellbox wiring terminals I'm used to) relay 1 being for sirens relay 2 for strobe 3 for pa and 4 for reset, now the issue I'm having is the relays it seems to be indicating there seems to be two sets of relays both labeled in almost the same way except one is rio 0 then with numbered outputs 1-4 with what looks like a NC circuit inbetweeen then and then theres rio 1 which is also numbered 1-4 but without what appears to be a NC circuit section, theres doesnt seem to be a constant 12v output for the bell like im used to and the manual states that the relay outputs are under positive power via a 3k pull up resistor, now by now im pretty sure you can understand why I'm at a loss as to how to wire the bell boxes and my boss isnt exactly being helpful just being told to figure it out it. Here is how im used to wiring the bell boxes sab - panel 12v - 12v 0v - bell hold s- - bell- tmpr - sab tmp with a link on the bell between tmpf and 0v for tamper return Any help to point me in the right direction with be grately appreciated

Hey new here, I'm from Manchester been in the business for 3 and a half years mainly work with Gardtec 601 an Texecom premier joined the forum due to an issue with a galaxy dimension but dont seem to be able to post in the galaxy trade forum yet