ok success on. pulled everything to a table and started to test. Comes out to be the spring on the tamper switch on the pir was not getting pressed properly in any of the 3 devices. Unit going off installer mode now )
A second question if I may, does anyone know how to install a door detector pls.
Here is a pic of what I have.
Now to what I understand the yellow and blue one is the tamper.
The red and black do they go to a zone or to power 12vand 0 not sure.
My bet, goes to a zone and I break the serial link on the tamper loop and add this one as the same in serial.
Am i correct?
,
Raj