[Texecom Premier Elite Dialler Connection]

Thanks very much. Managed to get it working on pin 3, the dialing takes around 30 seconds from the alarm going off but guess this is normal.

[Texecom Premier Elite Dialler Connection]

Thanks for the reply.

The manual shows two different outputs;

8: Panel Output 1

OP1 is a low current (500mA ‘-ve’ applied) output (see page 31 for wiring details). The output is also fully programmable (see page 69 for programming details).

And

16: Digicom Outputs

Outputs 1 to 8 are low current (100mA ‘-ve’ applied) and would normally be used when connecting a stand-alone communicator to the control panel (see page 31 for details). Each output is fully programmable (see page 69 for details). A remote reset input and a line fault input are also provided.

Are the Digicom ones the ones to use?

Thanks

Si

Sorry sixwheeledbeast, just seen your response.

Thanks very much.

How come 3 doesn't require programming?

[Texecom Premier Elite Dialler Connection]

Hi All

I appreciate this is a fairly simple question, but this is a first Texecom install - which terminal on a Premier Elite 24 PCB should I connect my ADE Honeywell Informa Speech Dialler to?

I had tried connecting to Bell+ but although I can make a test call from the dialler itself it does not dial when the alarm is triggered?

Thanks in advance for any assistance.

Si