Thanks for the reply.
The manual shows two different outputs;
8: Panel Output 1
OP1 is a low current (500mA ‘-ve’ applied) output (see page 31 for wiring details). The output is also fully programmable (see page 69 for programming details).
And
16: Digicom Outputs
Outputs 1 to 8 are low current (100mA ‘-ve’ applied) and would normally be used when connecting a stand-alone communicator to the control panel (see page 31 for details). Each output is fully programmable (see page 69 for details). A remote reset input and a line fault input are also provided.
Are the Digicom ones the ones to use?
Thanks
Si
Sorry sixwheeledbeast, just seen your response.
Thanks very much.
How come 3 doesn't require programming?