Jump to content
Security Installer Community

Texecom Premier 48


Guest Surj

Recommended Posts

I have just installed this alarm system and it was working ok. I had made a few changes by going into the panel box and plugging my PC to it in engineers mode but after making the changes and refitting the panel lid and exiting engineers mode I get the Panel lid tamper on the display and I am unable to set the alarm? I have read the installation manual and I can't find anything about resetting this tamper. Does any1 know what I need to do?

Surj.

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.