Search the Community
Showing results for tags 'eol'.
Found 1 result
-
Hi all. I best start of saying I'm a complete beginner when it comes to alarm systems as you'll probably guess. I have a Honeywell Flex 20 and a keypad and a couple of budget PIR motion sensors to test out wiring EOL before I buy more (better quality) and install. On the manual its shows 8 connections on the sensor. 2x Faults, 2xTamper, 2x Alarm 2 Power. But on most of the motion sensors I've seen they only have 6 connections. 2xTamper 2x Alarm 2x Power The manuals showing me where to wire the resistors including into the 2 fault connections but how do i wire the resistors if I only have the 6 connections? I watched a couple of YouTube videos and I'm thinking I may have it right but now I'm not sure how that wires to the board as again the manual shows the fault connections being wired to the board. I've attached a couple of pictures from the manual and one from the sensor I think it's wired right, you'll have to ignore the wire colours as I'm using old cat5 cable for testing. Also another part what should be easy is if I'm not using a zone on the alarm I'm not actually sure where to wire them. Sorry for the fact questions and thanks for any help.
