[XR2 stuck in tamper mode!]

29 minutes ago, james.wilson said:

the tamper is probably global, not just the tamper spring on the panel.

One of them will be open circuit either the sab you have replaced or the tamper input

So in basic terms something isn’t wired correctly ?

[XR2 stuck in tamper mode!]

13 minutes ago, NEWDIY said:

XR2

Apologies it is a XRI

[XR2 stuck in tamper mode!]

Hello,

 

I have just installed a new Pyronix Deltabell plus and a new battery for the alarm panel. (Citydell XR2)

 

As soon as I power it up from either the mains or connecting the battery it goes straight into tamper mode. (Even if the tamper spring is depressed)

 

I can then input my code to silence the alarm, but after this the keypad goes dead.

 

I cannot get it out of tamper mode and none of the keys make a noise when pressed like they usually do ! 
 

I’ve checked the tamper on the deltabell plus and the cover is definitely pressing the switch down.

 

Any advice ?

[Citydell XR2 to Deltabell plus]

1 hour ago, sixwheeledbeast said:

Thank you !!

[Citydell XR2 to Deltabell plus]

16 minutes ago, sixwheeledbeast said:

Oh a Citadel XR2... so an Accenta.

Bell comes with instructions follow the ADE one.

Five wires, negative strobe.

Unfortunately it was provided with no instructions 

[Citydell XR2 to Deltabell plus]

Old bell box has failed and needs replacing. I am happy doing everything just unsure on the wiring, please could you advise ?

 

Control panel currently has 

Strobe - (green

SCB - T(yellow

SCB - A (black)

Bell + (red)

Bell - (green)

13v + (red)

13v - (black) 

 

Deltabell plus 

T

T

ENG HOLD

STB

Bell

12v-

12v +
 

thank you so much in advance !