Jump to content
Security Installer Community

macca4848

Member
 View Profile  See their activity

  • Posts

    9

  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

macca4848's Achievements

Rookie

Rookie (2/14)

  • Week One Done Rare
  • Dedicated Rare
  • First Post Rare
  • Conversation Starter Rare

Recent Badges

0

Reputation

  1. macca4848
    ? yep, put a brand new battery in when i moved it - maybe it doesn't like this battery and another new one would help...#clutching
  2. macca4848
    Its been working for a year no problems. I just moved it and put a new battery in and now its giving me a warning...i might just change the battery and see if it solves
  3. macca4848
    The one that's giving me problems was direct from orisec...but i have bought a couple of other orisec boxed ones from ebay - are you going to tell me they are rejects from Orisec
  4. macca4848
    All sorted now with engineer code thanks al Now got thr new wireless device with new battery giving me a “low battery” notification. Even though showing 2.8v on the panel??…anyone had this
  5. macca4848
    ? - switch off the mains and disconnecting the battery? And that will restore factory default codes and I’ll start again
  6. macca4848
    Ahh. I wonder if I have inadvertently done this….how would I go about getting the code of the day to reverse this.
  7. macca4848
    Code of The Day? Can this be done in the remote keypad? I’ve not had the control panel open as I’ve just been adding wireless zones.
  8. macca4848
    no I didn’t change. The remote panel recognises the code as when I enter the 4th digit it does an error beep and code disappears. If I don’t enter the correct code the 4th digit doesn’t do anything and I have 4 * * * * on screen until I press enter. So I know the code is correct. Might have to powercycle it, yes
  9. macca4848
    I've been adding bits to an Orisec system, however the 4-digit engineer code has stopped showing up the engineer menu. I know it's the right code because it recognises the 4-digits, but makes an error beep on the last digit and doesn't open up the menu - any ideas? back working on it tomorrow
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept