Amit
-
Posts
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Downloads
Gallery
Blogs
Posts posted by Amit
-
-
cables are all under floor and not under carpets
-
14 minutes ago, al-yeti said:
You wire the pir incorrectly near keypad?
What you mean after reset ?
user code reset,not full reset. tamper to pir,s wired ass global tamper in series
Pir,s are texacom compact pir, checked for tamper loop on each pir back to panel and ok
-
3 hours ago, sixwheeledbeast said:
Could be bell/panel or wire between. depends how it's all wired.
If external tamper was linked and bell duff could feedback to internal with no log events, for exmaple.
External bell tamper not Linked.
internal bell is a speaker, i have checked the wires to external bell with a meter and all 5 cores tested ok.
Yes I do suspect external bell but passes bell and strobe test.
Z1 =Front door contact.
Z2 = Hallway Pir
Z3 = Reception Pir
Z4= Dinning Pir
Z5 = Kitchen and Garage Pir
Z6 = Landing and front room Pir
Z7 = Main bedroom and Back room Pir
Z8 = Down stairs Upstairs PA.
-
4 minutes ago, MrHappy said:
Outside box ringing ?
or something different ?
yes bell box rings so does internal bell
external bell plus internal bell rings but no display on keypad and no log information
-
Scantronic 9651 alarms even when on installer mode, keypad does not show any faults or fault code, on log menu no fault activity shows, all voltages and tampers working ok, is this apanel fault?
After reset and on user mode alarms. but again no fault code on keypad, again log does not show any faults.
Scantronic 9651 unusual fault
in !!..DIY Installers..!!
Posted
yes Alarm, cctv and door entry systems retired now just helping a friend