[Cooper Menvier 9651 - Set up guide?]

1 hour ago, james.wilson said:

well id be looking to prove the panel, looping out the circuits. I suppose you could have a voltage on a leg. You didn't connect the battery the wrong way round did you?

 

Nope, double checked and battery went in the same connections as the old one. 

1 hour ago, al-yeti said:

Try linking the tamper circuit , close everything up and see if it starts to arm 

 

How do i go about linking the tamper circuit? When i remove the unit cover, the tamper internal alarm does sound and i have to punch in the code to stop it. 

[Cooper Menvier 9651 - Set up guide?]

Ok in engineer mode under command 21 it says:

CC+ComA/T

 

 

[Cooper Menvier 9651 - Set up guide?]

Hi photos of the pcb wiring uploaded. The PIRs seem to be working as they light up when someone is in the rooms. 

[Cooper Menvier 9651 - Set up guide?]

I recently replaced the dead battery in my Cooper Menvier 9651 alarm and whilst trying to clear the fault codes I stupidly reset all the commands to default and therefore now need to reprogram it from scratch.  I have the installers guide and tried my best setting it up with this but cant seem to get it up and running.  There's only one door contact and 5 PIR in the system which I have set as  'Final Exit (FE)' for the door and 'Normal Alarm (NA)' for the PIRs, the last two zones are set as 'Not Used'. But whenever I try to arm it, there's not a count down sound to exit and the unit just cycles through the zones and doesnt actually arm.  I may resort in getting some professional in to set it up, but I was wondering if anyone can provide some guidance in case I have missed something.

 

Thanks