By the way, do not attempt to flash the firmware yourself. This really should be done by an approved supplier or Visonic themselves, your friendly engineer should know who to contact, if not he can call me and can point him in the right direction.
Firmware has been changing over the last few years but most PG2 components are fully compatible, few exceptions are the Plink - you may need an older version - but the siren should be fine. However, Powercode (Powerwmax) and PG2 (Powermaster) are completely different.
If unsure of the compatability of the kit and if it should be used in the UK, let me have images of the information labels for the Powermaster 10.
The MCS Siren is for the Powermax range. You need an SR-740 PG2
Has the Powermaster 10 been installed?
To install the Plink the panel must be fully powered down then fit the module in the correct position on the board with the appropriate ribbon cable.
You need to connect the Plink to the router - must be hard wired.
Configuration is fairly involved but access is available to a free Visonic/Tyco server
Can call over and install etc. as not too far from Manchester
Hope this is of use
Just a few words to introduce myself. We are a Gold installer of the Visonic wireless range - generally in the Greater Manchester area.
Also install CCTV - both AHD and IP and access control (mainly Paxton with small Videx systems)
We encourage clients to take systems that can be accessed remotely, particularly by smartphone/tablet.
Customer base predominately residential and SME
Training has been with manufacturers of the products I install.
That's about it unless someone needs a CV to help them sleep at night.