[Scantronic 9651 zone route query]

1 minute ago, al-yeti said:

You have a prox keypad?

Yep

[Scantronic 9651 zone route query]

6 minutes ago, al-yeti said:

Well you could leave in installer.mode , disconnect keypad wires in panel and go replace.keypad 

 

Or some here would just swap it over live , depends on how brave you feel 

 

Or "happ"ily drill through wall and reach for keypad through hole for fun of it and have filla ready

Aha alright guess I give it a try when the new keypad arrives, hopefully it goes smooth. Thanks.

[Scantronic 9651 zone route query]

9 minutes ago, sixwheeledbeast said:

Shouldn't need to default a panel to replace a keypad.

 

Zone options for Set B can be programmed separately from A, if you know how to program it.

Yeah I see now; just couldn't find the correct program number, sorted that problem thanks. So how would I go about replacing the keypad? If I remove mains & battery does it not default? Therefore leave the battery in and remove mains and just replace the keypad in installer mode (so that it doesn't trigger the alarm)?

[Scantronic 9651 zone route query]

I have 2 issues, firstly I want to setup the alarm part set B for night; so that it triggers the timer when you enter the hall, the problem is the hall is set as an entry route for the full set A and the other part sets (the doors are final exits..), so the only way to trigger the timer is putting the hall zone as a final exit too would that conflict with the doors/other settings? Is there a correct way about doing it? I don't want to put the upstairs PIR to final exit because it would trigger if someone went to the bathroom.

I also need to replace the keypad because the one I have is broke & touching it can sometimes cause a tamper alarm, I've ordered a new but need a way to install it without defaulting the system (don't want to reprogram it again), is there a way to do this? if I turn the mains off and put the keypad in installer mode and just changed the keypad there would it cause any issues? Or do I need to turn everything off and reset all the settings?