omegauk

Thank you for your advice and I am going to do as you say on Monday, at the back of my mind I knew I should of bridged all zones before starting. but it was 15 years since I fitted one lol

when the panel came this morning, there was no bidges in the 8 zones. Only 1,2,and 3 zones are been used now. I have replaced all the wiring the same way it came out. the sparkie used blue/white for the tampers on the wiring and I replaced them

when I first went to see it I was told the battery as just been taken off, so don't think so. but even when you connect to the mains and you get power light on, there is no sound from it at all even the tampers are not bridged.. and also the keypad does not light up or respond when the buttons are pressed.

As far as I know the alarm system was a new one put in by a electrician, they phoned him but he will not come back. it is a new battery, so I will check what you's have said.

the old one was light up but could not do anything with it, but when my son phoned me about it the alarms where sounding. I have checked the fused in the new box and they are fine

Hi, I am new to this site so first time post. I was called to a faulty panel, which I took out remembering to mark where the wiring went in the box. A replacement came this morning and I have fitted it carefully putting the wires in the right slots including the remote panel. I connected the battery with the tamper spring down and got nothing when I let the spring go causing a tamper. thinking the battery was flat I closed the tamper spring again and connected the power and I got the power light on, released the tamper spring and got nothing, no beeps no siren. can anyone please help put me right, Thanks David.