[Texecom premier elite remote bell box]

Thanks for the reply, I forgot the 8xp expander board in the psu had outputs. I'm guessing I just need to program an output to go low on alarm.

[Texecom premier elite remote bell box]

Hello, I've got a new house and I'm planning to fit a premier elite 48 pannel to the house and then run a data cable through existing ducting under ground to the separate garrage block. In there I was going to install a psu200xp and dual tech sensors to the expander. But I was wondering if I could fit a op16 and have it trigger a bell box if the panel is triggered. Has anyone done this. I know you could wire it as a scb from the panel but wondered if I could wire the remote bell box as a sab using the 200xp and op16?

 

Thanks in advance.

[Cpx Alarm with hybrid wireless]

Sorry for the late reply, I went to the house today as I've not moved in yet. I went into zone attributes and zone 1 was on test which is also the entry exit zone. I took it off test and all is good. 

 

One thing I don't understand is why it wasn't wired as eol as it seems much better.

 

Thanks again everyone for your help

[Cpx Alarm with hybrid wireless]

Thank you all for the responses guys. Seanh that makes alot of sense, the last thing that was installed was the hybrid wireless so I guess he was doing it for testing.

 

Kind regards

 

Trev

[Cpx Alarm with hybrid wireless]

Hello, I've just moved house and it has a risco cpx Alarm and a hybrid wireless module. The problem is when I go to set the alarm, I enter the user code and then press yes when it asks if I want to set the alarm. Then the alarm shows the following screen.

!Zone/s on test!

No to continue

To which you have to press no.

Why does this screen show and can it be disabled?

 

Also I've got a 4 button key fob which I've paired but how can I make one of the buttons do a part set? I've looked in the eng manual but could not see anything  obvious. My old alarm was a texecom and it was far easier to program.

 

Many Thanks

 

Trev.