Hi Folks,
I realise this question may be outside of the scope of the public forum but any clues would be much appreciated.
I'm having a bit of trouble with a galaxy G2-44 endstation that is installed in my friends shop. Until recently it was serviced by a local company however they are no longer in the alarm trade and are unable to help.
The system has been out of use for sometime and no one knows any of the codes.
I've tried to default the system by removing connections to 1001, etc, etc. I left it dead for 10 mins and when powering up it will not accept the default user/engineer codes.
I'm not actually sure if it has successfully defaulted, or if it has non-standard default codes (hard coded) in the panel by the installer.
Any help would be much appreciated.
Dan