Therealme

I have been advised that apparently it's a straight swap, the terminals are marked up differently but have had it explained to me in detail how to connect it to my Accenta panel The unit mentioned above seems very basic and might not be enough for what I 'might' need in the future, is it expandable, has anyone used/ fitted one? Thanks everyone for all your advise so far, I really appreciate it. Ron

Thank you for the reply can you recommend anything? Always open to suggestions if there is something better for les cash Ron

Hi all, I am new here and found you all when looking for some information, hopefully someone here can help me I currently have a Honeywell Accenta Gen 4 alarm with a Informa speech dialler connected, as I no longer have access to a fixed telephone line I was looking to replace my dialler with a Pyronix speech dialler GSM V2, can anyone tell me if it would be a direct replacement and I just need to disconnect existing wiring and reconnect to this dialler please? I assume the connections are as follows Informer V2GSM 12V ------ +12V 0V ------- 0V IP1 ------- IN1 (IP1 is connected to INT on my main panel) IP2 ------- IN2 (IP2 is connected to PA on my main panel) IP3 ------- IN3 (IP3 should be connected to FIRE on my main panel - CURRENTLY NOT USED) INH ------ IN6/S (INH is connected to set on my main panel) T A -------- TAM 1 M -------- TAM 2 P I have attached a photo showing the connections on my currently fitted Informa and a PDF showing the relevant pages from the panel connectionsGen4_Dialler connect.pdf. Thanks in advance Ron