Jump to content
Security Installer Community

Archived

This topic is now archived and is closed to further replies.

Guest jstr

Scantronic 816

Recommended Posts

Guest jstr

Hi There

I took over an office in January that has a Scantronic 816 control panel. The outgoing tenant had long since cancelled his //.National Installer.// contract, and they just carried on setting the alarm, which all worked fine.

They passed on the codes to me, and that's been fine until a couple of days ago, I tried to change the codes as we had staff leave. Now it stubbornly says "Call Engineer". The conversation with //.National Installer.// was most unhelpful.

Is there (a) anyone out there who can reset this system, or better, (b) someone who can tell me how to do this.

We are a very small company, and I don't want to pay for a contract just yet - it might be worth paying for a single visit or else I'll just have to change the lock

Hope someone can help - thanks

Share this post


Link to post
Share on other sites
Guest

First off, where are you? Resetting the system and programming to your requirements is a relatively simple job.

Share this post


Link to post
Share on other sites
Guest jstr

We are in Beech Hill, Reading, Berks, 3 miles South of Junction 11 of the M4

Share this post


Link to post
Share on other sites
We are in Beech Hill, Reading, Berks, 3 miles South of Junction 11 of the M4

49437[/snapback]

I cover your area, PM me if you would like me to visit!

Share this post


Link to post
Share on other sites

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.