Guest jstr Posted April 18, 2005 Share Posted April 18, 2005 Hi There I took over an office in January that has a Scantronic 816 control panel. The outgoing tenant had long since cancelled his //.National Installer.// contract, and they just carried on setting the alarm, which all worked fine. They passed on the codes to me, and that's been fine until a couple of days ago, I tried to change the codes as we had staff leave. Now it stubbornly says "Call Engineer". The conversation with //.National Installer.// was most unhelpful. Is there (a) anyone out there who can reset this system, or better, (b) someone who can tell me how to do this. We are a very small company, and I don't want to pay for a contract just yet - it might be worth paying for a single visit or else I'll just have to change the lock Hope someone can help - thanks Link to comment Share on other sites More sharing options...
Guest Posted April 18, 2005 Share Posted April 18, 2005 First off, where are you? Resetting the system and programming to your requirements is a relatively simple job. Link to comment Share on other sites More sharing options...
Guest jstr Posted April 20, 2005 Share Posted April 20, 2005 We are in Beech Hill, Reading, Berks, 3 miles South of Junction 11 of the M4 Link to comment Share on other sites More sharing options...
Deltaseven Posted April 20, 2005 Share Posted April 20, 2005 We are in Beech Hill, Reading, Berks, 3 miles South of Junction 11 of the M4 49437[/snapback] I cover your area, PM me if you would like me to visit! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.