Guest spike1986uk Posted January 14, 2005 Share Posted January 14, 2005 Hi all. I've just installed a Gardtec 350 panel and I want to do a part set routine to omit zones 1 & 3 (it's less emotionally crippling than killing the cat). I can manage omitting the zones manually but my missus is not very logical. The problem is the installation manual, I can't make head or tail of the part setting bit. Can anyone help please? Spike............. Link to comment Share on other sites More sharing options...
Service Engineer Posted January 14, 2005 Share Posted January 14, 2005 The part setting is programmed when you set up each zones attributes. EG: Setting the front door as 0114, would mean you have set up zone 01 as an E/E zone with the chime enabled. set up the zones you require to be part 1 omitted with the last zone attribute as 1, EG:If i were to program zone 3 with 0311, this would make zone 3 an Entry/Exit zone that is removed when the system is part 1 set. ........................................................ Dave Partridge (Romec Service Engineer) Link to comment Share on other sites More sharing options...
Guest spike1986uk Posted January 14, 2005 Share Posted January 14, 2005 The part setting is programmed when you set up each zones attributes.EG: Setting the front door as 0114, would mean you have set up zone 01 as an E/E zone with the chime enabled. set up the zones you require to be part 1 omitted with the last zone attribute as 1, EG:If i were to program zone 3 with 0311, this would make zone 3 an Entry/Exit zone that is removed when the system is part 1 set. 37124[/snapback] Thanks for the info. I understand the manual a little better now. I'll give it a whirl tomorrow Link to comment Share on other sites More sharing options...
Guest spike1986uk Posted January 15, 2005 Share Posted January 15, 2005 All sorted now TYVM Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.