Jump to content
Security Installer Community

C-TEC 2 Zone Panel with intermittent "General Fault" Alarm

Recommended Posts

Hi All,


Any suggestions appreciated!


I have a problem with a C-Tec, 2 Zone panel which keeps triggering the "General Fault" and "Power Supply Fault" beep.


There is only one Zone with 5 detectors.


The mains trip switch has been replaced, and the mains supply feeds a second panel, which does not have any problem.


The panel and backup batteries have been replaced.


There are no Zone Fault Alarm, and the detector are triggering when tested.


Any ideas what might be causing the problem ?



Link to comment
Share on other sites

You could try replacing the PSU but in my experience this rarely fixes it its normally the panel buggered down to the batteries not being replaced frequently enough

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.