Jump to content
Security Installer Community

GD 48 Help


David1

Recommended Posts

Hi everyone, I am to this forum and I am looking for some advice. Have recently bought a GD 48 alarm, C037 keypad and standby battery, I have also replaced the on board button battery. My problem is that the keypad is showing ************ and I cannot get past this on power up. Have read previous posts with no success con anyone help. Thanks

Link to comment
Share on other sites

4 minutes ago, David1 said:

Hi everyone, I am to this forum and I am looking for some advice. Have recently bought a GD 48 alarm, C037 keypad and standby battery, I have also replaced the on board button battery. My problem is that the keypad is showing ************ and I cannot get past this on power up. Have read previous posts with no success con anyone help. Thanks

What is the red LED on the main panel PCB doing?

Link to comment
Share on other sites

That's not right. Sounds like it's dead. When you apply power to a dimension, the relay should click and the red led should start flashing after about 5 seconds. 

 

I'm not sure it is one, but the ÂŁ50 panels on eBay are ÂŁ50 for a reason and are a bit of a gamble.

Link to comment
Share on other sites

10 hours ago, David1 said:

Cheers sounds as though I’ve been done

 

Well off from eBay , just hit not as described, or PayPal upto 6months to open case 

 

 

Edited by al-yeti
Link to comment
Share on other sites

58 minutes ago, David1 said:

I will have to check, as a matter of interest where is the led and relay situated on the board to check it is nothing obvious 

Both on the left side. The relay is next to the telecom connectors and the led is near the rs232 connector.  If it doesn't click, it's not usually anything simple.

Link to comment
Share on other sites

  • 8 months later...
On 03/12/2020 at 21:15, David1 said:

Hi everyone, I am to this forum and I am looking for some advice. Have recently bought a GD 48 alarm, C037 keypad and standby battery, I have also replaced the on board button battery. My problem is that the keypad is showing ************ and I cannot get past this on power up. Have read previous posts with no success con anyone help. Thanks

Did you sorted that?

Link to comment
Share on other sites

Old topic but ********** on the keypad mean they keypad isnt communicating with a panel, for whatever reason. In this case looks like a dud panel was bought, but on a previously working system its a data problem (cable)

  • Thanks 1

securitywarehouse Security Supplies from Security Warehouse

Trade Members please contact us for your TSI vetted trade discount.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.