Henrik Posted October 23, 2020 Author Share Posted October 23, 2020 22 minutes ago, al-yeti said: But we already told you where to start? Are you basically saying you don't have a clue how to find the manual to atleast wire the keypad to the control panel If you can't get that bit done , I would forget Bout this ..... Not at all, I’ll get it done. thanks for all the good advices. All I thought was since all you guys are obviously knowing what you doing with in low voltage security system you could give me some heads up in regards to the difference EOL resistors that’s already fitted to the system since it’s been installed ones before and I guessed the way of installing this system was pretty much the same all over the world since you all use the same numbers and markings. Im not a alarm system installer but if this was something that i knew I would sort of recognise the setup from what I saw in the pictures, just saying. But I’ll start all over again and figure it out. Have a great weekend everyone and stay safe in this Corona times. Quote Link to comment Share on other sites More sharing options...
Hillbilly Posted October 24, 2020 Share Posted October 24, 2020 So the system was installed before? Quote Link to comment Share on other sites More sharing options...
MrHappy Posted October 24, 2020 Share Posted October 24, 2020 If you want to be a DIY alarm man, put the controls on bench, link anything out & default it Once you have control of it & can get it fault free into day start adding detection circuits & learn how it works then try fitting it on the wall Quote Mr Veritas God Link to comment Share on other sites More sharing options...
Henrik Posted October 24, 2020 Author Share Posted October 24, 2020 48 minutes ago, Hillbilly said: So the system was installed before? Did you not read the posting??? Quote Link to comment Share on other sites More sharing options...
al-yeti Posted October 24, 2020 Share Posted October 24, 2020 3 hours ago, Henrik said: Did you not read the posting??? This is UK , we don't read anything , especially manuals until we desperate Quote Link to comment Share on other sites More sharing options...
PeterJames Posted October 24, 2020 Share Posted October 24, 2020 4 hours ago, Henrik said: Did you not read the posting??? Its why I said shorten the posts down, we get bored after the second sentence, one question at a time, you will get more sensible replies Quote Link to comment Share on other sites More sharing options...
MrHappy Posted October 24, 2020 Share Posted October 24, 2020 6 hours ago, PeterJames said: you will get more sensible replies sounds very unlikely ? 1 Quote Mr Veritas God Link to comment Share on other sites More sharing options...
PeterJames Posted October 24, 2020 Share Posted October 24, 2020 1 minute ago, MrHappy said: sounds very unlikely ? okay a higher chance then 1 Quote Link to comment Share on other sites More sharing options...
PeteGBR Posted October 25, 2020 Share Posted October 25, 2020 Pastel themed wiring scheme - That's art. Quote Link to comment Share on other sites More sharing options...
Henrik Posted October 28, 2020 Author Share Posted October 28, 2020 Ok guys, got everything up and running just fine. i do however have an slight issue. when I took the alarm down I most have missed one PIR hanging on the wall (address 1002). how do I go about entering the engineer code to be able to delete the address 1002? And is the engineering code always the same or is it changeable by the company who first installed the system in my old shop? thanks in advance, Henrik. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.